Conjugate heat transfer

CHT couples fluid heat transport with conduction in solid regions. Use a verified multi-region mesh and select simulation_type="cht". The current turbulence choices are SST or laminar; laminar uses low_re or none wall treatment.

Materials and loads

config.thermal identifies the actual fluid_zone_names and solid_zone_names. Supply conductivity k_per_zone in W/(m·K), density rho_per_zone in kg/m³, and heat capacity cp_per_zone in J/(kg·K) for the required zones. Properties must describe the intended material and operating state.

Use heat_source_w_per_zone for supported total zone heat input in watts, or surface_heat_sources for supported boundary loads. Read each source’s schema; total power and heat flux are different quantities. Select real mesh boundaries and preserve the physical area used by the load.

Specify inlet temperature in kelvin and the relevant inlet/outlet patches. Check that fluid properties, flow rate and reference temperature are consistent. A thermal source does not establish the coolant flow condition.

Coupling controls

Discover thermal controls through get_solver_controls with simulation_type="cht". The public catalogue includes conjugate-solver selection, fluid/outer tolerances and iteration limits, interface acceleration, turbulent Prandtl options, thermal wall treatment, precision and supported solid contact resistance. Use exact names and validate combinations before overriding defaults.

Qualify the result

Review fluid and thermal convergence, temperature bounds, pressure drop, heat removed by the coolant, applied power and interface behaviour. Report energy imbalance and material/property assumptions with peak temperature or thermal resistance. Check spatial resolution near heated surfaces and through thin solids.

References: ThermalConfig, SurfaceHeatSource, multi-region meshing.