Thermal request exampleΒΆ

This request illustrates laminar CHT with a fluid region named coolant and a solid named plate. Replace all identities and physical properties with verified data for your mesh and operating point. The values below are illustrative constants, not a qualified material model.

{
  "mesh_artifact_id": "REPLACE_WITH_MESH_ARTIFACT_ID",
  "config": {
    "architecture": "fluxcore",
    "simulation_type": "cht",
    "turbulence_model": "laminar",
    "wall_treatment": "none",
    "fluid": {"density": 997.0, "viscosity": 0.00089, "molecular_weight": 18.015},
    "cht_inlet_temperature": 298.15,
    "boundary_conditions": {
      "inlet": {"type": "inlet", "value": {"velocity": [1, 0, 0], "temperature": 298.15}},
      "outlet": {"type": "outlet", "value": {"pressure": 101325}},
      "walls": {"type": "wall"}
    },
    "thermal": {
      "fluid_zone_names": ["coolant"],
      "solid_zone_names": ["plate"],
      "k_per_zone": {"coolant": 0.6, "plate": 200},
      "rho_per_zone": {"coolant": 997, "plate": 2700},
      "cp_per_zone": {"coolant": 4180, "plate": 900},
      "heat_source_w_per_zone": {"plate": 100},
      "inlet_patch": "inlet",
      "outlet_patch": "outlet",
      "reference_temperature": 298.15
    },
    "export_solution_fields": true
  }
}

Validate with POST /v1/simulations/validate or validate_simulation, estimate, and submit only after confirming region assignments and the intended operating regime. Structural validation does not establish that a particular coolant/material combination is qualified for the connected solver or that the assumed laminar regime is appropriate.

Use ThermalConfig for field types and thermal modelling for units, coupling controls and energy-balance checks. surface_heat_sources are a separate supported load definition with explicit zone and footprint geometry; see SurfaceHeatSource.