Cold plate: design to thermal result

Objective: evaluate pressure drop and temperature under a declared coolant flow and heat load. A template is a starting geometry, not a validated layout for a particular electronics package.

Design and inspect

Discover cold_plate through get_template, including parameter units and ranges. Create a concept or edit a self-contained implicit document. Set the envelope, channels, ports and mounting requirements, then inspect sections for continuous flow and sufficient material thickness.

Retain named material and actual coolant volumes for the chosen CHT route. Exclude heat-load display footprints from physical volume exports. Check the source and exported dimensions.

Prepare the CHT mesh

Inspect the supported geometry route and required region inventory. Use the dedicated cold-plate preparation operation when applicable, following its current schema and returned artifacts. For an explicit multi-solid STEP workflow, supply real fluid/solid volumes and validate cht_step settings, port selections and layer count.

Estimate and submit one reviewed mesh request. Inspect actual count, quality, port names and interface coverage. Accept an out-of-target verified candidate only after reviewing the returned evidence.

Configure Fluxcore

Choose laminar CHT or SST CHT according to the physical regime and supported setup. Supply coolant properties, solid conductivity/density/heat capacity, flow conditions, inlet temperature and heat input using the actual mesh zones and surfaces. A heat source in watts is not a heat flux value.

Validate and estimate, then submit. Monitor fluid and thermal convergence and inspect the saved result. Report peak temperature, pressure drop, applied power, heat removed and energy balance using clear definitions.

Handoff

Keep geometry and mesh identities, parameter values, material assumptions, convergence criteria and sensitivity evidence. A predicted result from a reduced model must retain that model’s evidence label and cannot be presented as a newly completed CFD run.

Exact operations: geometry, meshing, thermal setup, and MCP tools.