Name physical bodies and simulation regions¶
Named outputs carry design meaning into meshing and simulation. Use names such as housing, coolant or insert for actual material volumes. Keep display helpers, heat-load footprints, construction tools and boundary-only geometry out of the physical-volume output selection.
Conjugate heat transfer¶
CHT requires fluid and solid regions with explicit material assignments and shared interfaces. Create a real coolant volume for the meshing route that requires explicit fluid bodies. A cavity subtracted from a solid is not, by itself, a separate fluid body in an exported assembly.
Check for overlapping volumes, gaps at intended contacts, disconnected passages and accidental duplicate bodies. Use the design service’s simulation-region operations to inspect the available semantics, then verify the exported mesh’s actual zone labels before setting thermal or rotating-region controls.
Boundaries and identities¶
An output name is not necessarily a structured-meshing component ID or a final mesh patch name. Those identities come from inspection of the relevant artifact. Retain mappings from document output to exported body to mesh region, and select boundaries from the mesh’s returned inventory.
For named STL export, use named_stl=true with explicit volume output_names and STL output. Keep the returned per-body artifact identities. For multi-body STEP, inspect the actual exported solid names and the mesher’s region report.
An agent should stop before simulation if an inlet, heated wall, material zone or rotating cell zone cannot be identified unambiguously. Guessing a name can apply a valid setting to the wrong physical region.